This preinstalled driver makes the computer LAN-ready for a computer running 
Windows95/98 when it is connected to an optional 10/100 Network Port
Replicator.

The following parameters can be specified to optimize the computer's LAN
performance. You can use the default settings,however,you may need to set the
duplex mode and speed to match the LAN hub's functionality.

Follow the procedures below to change LAN parameters. Be very careful when
making changes.

1. Open the Control Panel.
2. Double-click the Network icon.
3. In the Network Componets list box, select the LAN adaptor
4. Click the Advanced button.
5. Set the Duplex Mode to Auto Duplex(default), Full Duplex or Half Duplex.

   Auto Duplex: Automatically recognizes a full-duplex switch and uses full
   duplex when possible.

   Full Duplex: Packets can be sent and received simultaneously.
   Half Duplex: Packets cannot be sent and received simultaneously.

   Note: If you set the duplex mode to full duplex or half duplex, you must
   set the speed to 100Mb/sec or 10Mb/sec.

6. Set the speed to Automatic(default), 100Mb/sec or 10Mb/sec.

   Automatic: Ajusts the speed to fit the connection.
   100Mb/sec or 10Mb/sec: If you connect another adaptor using cross cables,
   you must set the speed 100Mb/sec or 10Mb/sec.

For any other parameter, please use the driver's default settings.

						(NETTSBDC.TXT V1.00) 

